http://www.aerofly.com/www/requirements.html hat geschrieben:
Supported transmitters
The following radios are compatible with the AeroFly Professional Deluxe USB interface. Unless otherwise noted all of the ollowing radios except some JR and Futaba radios work with the included adapters:
* Graupner (FM-314, FM-414, MC10, MC12, MC14, MC15, MC16/20, MC18, MC19, MC22, MC24)
* Futaba (F14, FC16, FC18, FC28)
* Multiplex (Royal Evo-7/9/12, Profi MC 3000/4000, Cockpit MM, 2020, 3030, 4040)
* Lexors Nova 4 and Nova 6
* HITEC
* Sanwa
* Robbe
The following radios require a separate adapter:
* JR radios X-347, X-387, X-388, X-756, X-3810, 652, 8103, 6102/2610, 9X/9303, 10X and Graupner MX12, MX16 and MX22: These radios require a special 3.5mm mono adapter. This adapter is available direct from IKARUS (order number 31036) and its dealer network and from the dealer network of J. Perkins Distribution in Great Britain.
* Futaba radios 4YF, 6EX, 7C/FF7, 9C/FF9, 14MZ: The required square adapter is available direct from IKARUS (order number 31036) and its dealer network or from the dealer network of J. Perkins Distribution in Great Britain.
* Futaba FX-15 and FX-18: These radios require a 2.5mm mono adapter available direct from Robbe (Robbe order number 1-8383 (FX))
oder halt selbst bauen. Schaust du hier:
http://www.k-webdesign.com/modellflug/r ... 20dem%20PC
Rechte Spalte, einfach n Adapter von 3.5 Stereo (AFPD Dongle) auf 3.5 Mono (MX16 Schülerbuchse).
Sprich eine 3.5mm Stereo Buchse und einen 3.5mm Mono Stecker und etwas Kabel, dürfte nicht mehr als ein paar € kosten und ist ohne großen Aufwand herzustellen.
Oder halt die Variante mit Parallelport und mit PPJoy, sprich der Sender wird als Joystick eingebunden, kostet in etwa das gleiche und funktioniert auch mit FMS. Siehe
http://www.k-webdesign.com/modellflug/r ... len%20Port
Oder wenn dir das zuviel Arbeit ist halt ein USB-Interface fertig kaufen, wie bspw das oben genannte.
Wie man sieht führen viele Wege nach Rom